Alot of people are afraid to install LEDs because they dont know where to solder the wires or are just plain afraid to kill their 360. Its actually very easy to do. Here is a little tutorial for you to follow.
Items Needed
1. Soldering Iron
2. Solder
3. Electrical Tape
Your wires will either be
BLACK and
RED or
BLACK and
YELLOW.
On the picture below you will see where I soldered the black and yellow wires. Now if you have a red wire you will want to solder it where I placed the red dot on the right. All soldering is done on the back of the motherboard. After you solder the wires to the board make sure you cover them with the electrical tape.
Yellow=12v
Red=5v
Black=ground
After you are done you should have something like this.
__________________
To view links or images in signatures your post count must be 10 or greater. You currently have 0 posts.
To view links or images in signatures your post count must be 10 or greater. You currently have 0 posts.
|
To view links or images in signatures your post count must be 10 or greater. You currently have 0 posts.
|
To view links or images in signatures your post count must be 10 or greater. You currently have 0 posts.
|
To view links or images in signatures your post count must be 10 or greater. You currently have 0 posts.
|
To view links or images in signatures your post count must be 10 or greater. You currently have 0 posts.
iTrader = Masta Shake, cvst98 x3, h05tel, MrSchmo, ~Mike~, shadyfist, Jester2893